5015 Clear Fan Rear Housing

Experimental and untested.  Proceed at your own risk.

How to:

• Print in clear PETG.  Clean of strings well.
• Take a GDSTime 5015 fan and cut away everything down to the PCB (carefully).  Note that the back housing seems to act as a “cap” to the axle, exposing a clip and some lubricant.  Be careful and work slowly as to not put too much pressure on the motor and cause damage.
• Glue the PCB into the back housing.  Clip gently (the clip I used puts about the maximum amount of pressure I'd want on this thing as to not damage the motor)