Marble maze for the challenge there are technically 6 mazes and you need to get a small ball from the first to the last.
In the contest Marble Mazes
25
48
0
917
updated September 11, 2022

Description

PDF

Marble must be less than 13mm in diameter so that it can fit through all the sections

The Tunnel Pieces should be printed in orientation provided(if one is different change it to match the others) use supports that only touch build plate and the end of the tunnel that prints as a top surface should go into the smaller numbered maze (That is how i did it it should work either way). The tunnels have been shrunk down to 99% of their original size so if it is loose increase their size a little bit

The Mazes all should be printed in orientation provided you may want to use supports but it isn't necessary

 

To begin put the marble on the slightly raised square on face one and you can begin to finish the ball should be sitting nicely in the raised section on face six

 

Assembly Instructions:

Put pieces 1 and 2 together with their tunnel (You may want glue) also put "Tunnel 2-3" in with these pieces

Put pieces 3 and 4 together the same as above Also have the “Tunnel 4-5” with these peices

Put pieces 5 and 6 together 

Get the pieces that are 3 and 4 and put slide them into the correct spot with 5 and 6. 

Finally put 1 and 2 together with the rest it may be hard to get clipped in properly but it will eventually sort itself out

Tags



Model origin

The author hasn't provided the model origin yet.

License