LED Mounts for Delta printer

Inspired by Uhlala's FLSun QQ-S Led Strip, but that was too narrow for my led strip and didn't have mounting holes, so I whipped up a new one.

I don't know why you'd need this much light, so populate as many sides as you need. I started with just one, but two would be better.

Designed for a 8 mm wide strip light. If that doesn't work, resize to fit. The bolt holes won't care if you go bigger.

If glare is going to be a problem, try my light bar and install behind the front face.

Update 8/11/2021: Added a light bar for those with the printer on a high counter that would get glare from a centrally mounted light. Uses the same mount holes as the original delta style (if you don't need the 3rd mount hole.) The notches are for tie wraps.

Update 8/14/2021: Added 100mm longer version of the light bar. Also added tall version to direct the light down and light up the junk in the top less. This is probably the one you want.

Update 8/15/2021: Added tall version of light bar (193mm long), short enough to print on a smaller bed.

Update 8/16/2021: Added tall version of delta led mount.

Print Settings

Printer:

FLSUN QQ-S Pro

Rafts:

Supports:

No

Resolution:

Infill:

20

Filament:

Purple