Easy Ender 3 V2 Display Mount (Tight fit)

Installation:

1. Print parts
2. Remove original display stand from display & printer
3. Remove black cover from the bottom right aluminium frame
4. Insert printed parts on the 2 pins behind the display (1. Photo: make sure to place parts in the right direction)
5. Insert assembled parts slowly 1 by 1 into the top right extrusion hole of the frame
6. If needed: Cut the right amount of material of the top right corner from your drawer to not interfere with the display (2. Photo)

1. Place cover back on frame and make sure nothing interferes with printer bed / display

There might be a little force needed to place the parts in place since I designed it to have a tight fit. 

To test the stability of the design I did the mandatory wiggle test, applied some force at the corner of the screen but didn't note any problems and seems very stable.

Recommended printing parameters:

• 60% Infill
• 0.2mm Nozzle Diamenter 
• No support