Filament Color Tag System

Simple filament color tag system using a minimum of filament (29cm per swatch chip).

It takes approximately 4 minutes to print and add a new chip to the system.

Put the corresponding letter designation onto the filaments storage container (box, plastic bag, or other container).  Then record any information about that filament you wish (see picture with SAMPLE info).

The chips easily pop out (push hole in back with finger) for convenience.

I provided 3 cards each containing room for 8 chips.  If you have more than 24 filament spools and want more cards just let me know.

The ID chips are available in 2 sizes regular and snug (reg should work for most filaments).

Note: The chip tolerance is fairly small so you may find that some filaments are either too big or too small.  If this occurs, you can easily tweak the size using Prusa Slicers scale feature.