E3D Revo Voron mount for Anycubic Kobra Max

You need 2 M3 threaded heat inserts, 1 E3D Revo Voron, 1 PC4-M6 pneumatic fitting and 4  M3 16mm screws. Additionally, you will need 2 two-pin JST connectors to crimp the thermistor and heater wires as the Revo comes with installed DuPont connectors. Reuse the 2 M3 screws that join the leveling sensor mount with the Kobra Max V6 clone hotend. You can directly screw in the pneumatic fitting into the printed mount with no issues.

No supports needed. Print with ABS or other heat resistant filament. Used 40% infill but 20% infill should be fine. Printed at 0.24mm layer height.