Cable management clip for Microphone Arm Stand

Clip for holding the USB cable of my microphone, on the generic mic arm stand.

The cable in the picture is the original Audiotechnica AT2020USB+ cable, but it should work with most USB cables.

PS: It will NOT fit a XLR cable.

Suitable for 10mm square tubbing stand.

The usb cable is 4.4~4.5mm in diameter.

Theres a model for printing 2 at once to save some bed space.

I ended using 6 clips in total, 3 for each arm.

Print Settings

Printer:

Graber i3

Supports:

No

Resolution:

0.2

Infill:

100%

Filament: Generic ABS Black

Notes:

I printed using a 3mm brim for bed adhesion, 3 walls and 100% concentric infill (there's barely any infill anyways)

If you're printing only 1 or 2 of these, decrease the speed so the nozzle heat doesn't distort it. Or try using part cooling.

Category: Audio