SK-Tank Carriage Strain Relief Taller

I upgraded the extruder on my SK-Tank to an LGX and now the motor hits the strain relief. I quickly spliced in another ~10mm of length to this to make it taller. 

Retains the same 3 spots for zip-ties from the original. Mounts with a single button-head or countersunk M3x10mm. Recommend you use a nyloc nut with a washer on the part that touches the plastic. 

I would print this in something very rigid and like 100% infill to give the greatest stiffness possible. I'm trying 100% ASA and I will go to PA-CF if that's not stiff enough.