Funnel for 54mm Breville Bambino Plus Portafilter - Fits Smartgrinder Pro Cradle

I could not find a dosing funnel for my Breville Bambino Plus 54mm Portafilter (PF) which fits into the PF holder of my Smart Grinder Pro. The ones I have tried are too tall so I had to tilt the PF forward a little just so it goes through the cradle slot to reach the on/off activation switch, and the bottom spout hits the grinder tray. So I made my own funnel from scratch in fusion 360, though inspired by other's design like DogsBollocks and DrawnToDigital.

I used clear PETG at 20% infill so the infill lines are visible as shown in the photos.

PETG is preferred over PLA for food safety.

0.4 nozzle

0.2 Layer height

Supports: Yes

Place bottom side up in the bed for cleaner prints.