Wolfie and Wrench (Wolfworks3D variant)

This is a simple variant of my Wolfie model for WolfWorks3D. Go follow @wolfworks3D on Twitter and see what it's all about.

Please note that I am not affiliated to Wolfworks3D in any way nor do I endorse their products. This was done as a friendly gesture in these troubled times.

There are two complete models here

1) For single material:

wolfie_and_wrench_single_extrusion.stl

2) for MMU:

wolfie_and_wrench_body.stl

Featured prints and photographs taken by Wolfworks3d.

Concept sketch was drawn and is owned by Louise Driggers

Original wolfies can be found here:

https://www.prusaprinters.org/prints/25244-wolfie-multi-material-wolf-cub-model

https://www.prusaprinters.org/prints/25243-wolfie-supports-free-wolf-cub-sculpt

Print instructions

At the default scale, this model prints without supports, however increased scaling will likely require it.