Not Another Toothpaste Squeezer

Not Another Toothpaste Squeezer

I made this after seeing the initial wave of toothpaste squeezers. I wanted parts printable without supports, and for my toothpaste tubes I needed a slightly larger opening.

Also featured in the photos are my toiletries organizers.

Key Dimensions

The opening is 4.00 mm wide and the twister slot is 2.63 mm wide. 

Printing Advice

I printed these with 0.15 mm layer height and the Quality preset and strength-oriented parameters (6 perimeters in particular). I printed the squeezer in PLA but the twister (the handle) in PETG for extra strength as that is the part that experiences the most stress.