Water Spacer

This spacer allows you to assemble the Fountain to the Pump without the need for a plastic hose.  Gently press the pipe spacer onto the Water Pump,  then push it into the Plateau Fountain outer curved edge to the top, inner curved edge to the bottom. Gently lower complete assembly into the area you want.  

This is for the “ Deep Base ” Remix only

The water pump is the same as used in the original Modular Desktop Fountain. 

You may need to sand a bit to fit if your printer isn't dead nuts on Calibration. It should be just able to slip on the pump spigot and into the bottom of the Fountain.