Voron 2 LDO Orbiter Drag Chain Mount

I found that the Voron 2.4, Orbiter1.5 Mount by madsgadeberg didn't include a drag-chain mount. It would also position the extruder too low such that the extruder motor would bind up on the drag chain.

This is a remix of both Voron 2.4, Orbiter1.5 Mount and Orbiter LDO Motor Drag Chain Mount (10.x11) by Evilged

The drag chain mount referenced above would also extend too too far out the back such that the drag chain wouldn't lay properly across the 2020 extrusion.

I raised the extruder mount piece up extra 4mm and created the mount so that it looped over the top of the motor. Like the Orbiter mount and the Voron in general, it's designed to use M3 heat-set inserts.

I also included the Fusion 360 design files to make further remixes and updates easier.

Print Settings

Printer Brand:

Prusa

Printer:

Prusa Clone

Rafts:

No

Supports:

Yes

Resolution:

0.2

Infill:

40

Filament: Generic ABS Red or Black or whatever

Notes:

Used ABS since that is the standard filament spec'd by the Voron team.