Made 6 of these for wall mounting some of my EGO batteries. (edited)
Smooth EGO battery holder / mount
Mount your EGO Power+ batteries to keep them off the floor or tables!
41
310
6
1292
updated September 7, 2024
Makes
Comments
Printed in Inland Orange PLA+
Used 25% cubic infill and it’s still crazy strong.
A little snug on 0.28 superdraft settings, but very good design.
I cut off the bottom so it could print vertically without any supports. It still works as intended.
Printed with petg, 3 external shells for extra hardness.
@Weaponsmith do you think this added significant strength to print in this orientation? do you think that it was inadequate to print laying flat? genuinely curious
@KoryHerber_1597524 I only did that so I didn't need to print supports for the overhangs
Turned out great and holds very well! Didn't fit my particular pegboard (hole distance is different) but even mounting with 1 screw it's super stable and plenty to hold the batteries. I like the rounded corners, they hug the inner wall of the battery well!
