Corner Radius Routing Jig 10,15,20,25 mm

I designed a corner radius routing jig to route inside and outside corners with a radius of 10, 15, 20 or 25 mm with a flush trimming router bit. The edge guide of this jig can be mounted outwards or inwards to allow both types of corners.

You need two pieces of angle profile with 15 mm width which are cut to 30 mm length and two M3 screws (M3x8 mm) for the edge guide. I used a M3 screw tab to prepare the thread in the already printed hole.

print with the numbers on top