I hated the way the other bltouch holders where mounted onto the carriage ( i even broke the threads on one of the carriage holes), so i decided to remix the blower holder limon3d made in his awesome design for the P902. This is much better imho.
Offsets:
X = -31.65mm
Y = -50mm
Z = THIS OFFSET MUST BE MEASURED MANUALLY (it depends on the sensor's triggger point). I recomend this guide if you are using a duet board: https://betrue3d.dk/bltouch-on-duet-wifi-configuratio-and-usage/#configuring
Printer:
P902 (bowden e3d V6)
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
20-30%
Filament:
PrintaLot (argentinian brand) PLAGold
Category: 3D Printer PartsThe author marked this model as their own original creation. Imported from Thingiverse.