I made this remix because of two reasons. The first is that i converted my P902 into a hypercube, and the added corner brackets made impossible to use the previous case. The second reason is that i wanted to bolt the IEC socket i bought at my local store into the case, the previous version only worked with snap on type of sockets.
Additional changes:
-I elevated the back of the cover, in order the PSU to sit flush onto the case, previously there was a gap of aproximately 5mm.
-I added a reinforcement inside the case, in order to minimize the bending of the front wall when plugin/unpluging the main power cable.
-Moved the side holes for mounting the PSU to the case, as these were not aligned with the holes on my PSU.
IMPORTANT: My psu model is MS-250-12, DEPTH: 51mm, WIDTH:110mm. Check if you PSU has the same dimensions.
-Hardware needed:
screws ; m5x8 -3-pcs, m5x10 -4-pcs, t-nut m4 -4-pcs, m3x8 -1-pcs, washer m3 -1-pcs
zipties (as many as you like)
Printer:
Hypercube-inspired P902
Rafts:
No
Supports:
No
Resolution:
0,26-0,3
Infill:
50
Filament:
PrintaLot PLATranslucent Green
Category: 3D Printer PartsThe author marked this model as their own original creation. Imported from Thingiverse.