Adjustable 5015 Hemera Shroud with PINDA

I wanted to use a PINDA probe with a Volcano on a Hemera. Was using just the shroud and PINDA mount from this: https://www.thingiverse.com/thing:4076234.  Threw it into Fusion 360 and hacked together what I needed. The fan isn't super secure since it is only held by one screw, but it hasn't been an issue. Tthere is some sort of arm/filament sensor that I have not bothered with yet on the original thing. It is a dead work in progress, so I am not sure I ever will. 

The setup sticks out quite a bit in the -Y, but you shouldn't loose any build space on i3 type machines.

I modified what I assume is the original model (https://www.thingiverse.com/thing:4031637) to be capable of working with the PINDA mount. Including that file here as well since it is useless without it.

Offsets:

• X Offset: 26
• Y Offset: -33.8

Print Settings:

• Print with PETG or something with heat resistance
• 0.2mm Layer Height
• 20% Infill
• Supports from Build Plate only