NoClogClone Handle

This is a handle you can use if you want to create your own NoClogger device https://noclogger.com
 

This handle is designed to take a 1.6mm rod (the NoClogger version uses a 1.5mm rod).  

You will need a 1.5mm to 1.6mm diameter rod, with the length depending on the length from the tip of your hotend to your filament insertion point.  There is 1.5mm x 30mm deep hole in the design to make the insertion of the rod easier,  but i heated my rod before inserting it to make it easier.

i printed this in ASA, with a brim but i don't think its needed.   

Print orientation is as pictured.

just in case you are having a hard time sourcing your rod here's a link:

https://www.amazon.com/dp/B07KY8XJQL/?coliid=I132ULDJQS4F6A&colid=33BI8H756UJ6K&psc=1&ref_=lv_ov_lig_dp_it