Low Poly Skull Fixed (for normal and vase mode)

Low poly skull that's easily printable with vase mode (choose cut version to make a bowl)

I fixed bottom nose overhang angle, it's now prints without gaps
Also, bottom surface is now flat and without low steep overhangs

Full model has too steep overhangs on top to cover it properly in spiral

Printed model on photo is 400%

I usually print them with 0.9 perimeter width (external perimeter in Prusa/Super slicers), they are rigid and overhangs don't have holes with those settings

Original model by mcouno (?), low poly by slavikk