Apple Airpods Max Headphone Hangar

Apple Airpods Max Headphone Hangar

• Printed in Prusament Recycled PETG
• .2mm layers
• 20% gyroid infill
• Printed flat on the closed back

I carefully measured and modeled a hangar for Apple Airpods Max noise-cancelling headphones. When in place, the load of the Airpods is distributed evenly over nearly the full length of the Airpods mesh. 

The hangar is sturdy, and feels like its in the proper scale when installed with headphones hanging on it. It affixes with one screw, which is recessed inside, making it easy to level, and very clean looking. 

When in place, Airpods will hang in very low-profile against a surface, but will not rub on anything except the hangar rest. The design saves precious desk/shelf space, and keeps your Airpods in excellent condition. 

While I did not care to do this with mine, I think it would also look cool doing a filament switch over the last .5cm or so of the print, as you could highlight a print with colored fillet edge. I may try mine again in a combo of dark-grey and silver to accent the Airpods.