Apple watch band stand

Now With 2 Versions!

Been working on a solution to my apple watch band addiction, so I made this! It's a two-part design: the base/stem, and the revolving carriage. No nuts or bolts needed, simply print the parts and slot the carriage into the base and you're good to go!

The carriage holds 15 watch bands! let me know if it's not enough!!

The two parts have a whole 1mm of clearance so the top should spin completely freely!

let me know how yours fares!

print at your favorite layer height although if you are impatient like me I'd suggest a large one like 0.2 or 0.28 as the whole stand is 7 inches tall.

base-Infill: 20-25 % -> mainly for added weight near the base to make it sturdy. although if you don't care for that go with as low as 10%.

carriage infill: from 15-25%

no supports needed!