Power Booster Circuit Holder (T64)

This is a simple model of a holder for a T64 power booster circuit board that measures 11mm x 10.5mm. It is not meant to be a stand-alone model, but to be added on to an existing project that needs this circuit.

The circuits I used this for can be found at the following location... https://www.amazon.ca/gp/product/B07L3RMJQB

The board should slide right in, and gently snap into place when pushed in all the way, but a dab of hot glue is probably a good idea if your print is going to have to endure a physical beating.

(the pictures I took above were of a print I did without supports ... supports are a good idea on this one)

Happy printing!

Print Settings

Printer Brand:

Monoprice

Printer:

Maker Select

Supports:

Yes

Infill:

100