RPi Camera Enclosure Front with LED Ring Holder

Added a ring to glue a 10cm LED ring to the front part of a raspberry pi camera casing from prodal's mount (see remix source).

Easy print with 0.2mm layer height; ring flat on base. Might want to use something more temperature resistant than PLA... like PETG or ABS. I printed in PLA though and had no problems so far.

Use some super glue or hot glue to attach the LED ring to the case's ring and make sure the cables are on the very bottom (there is a little relief for them), such that the ring fits tightly.

Print Settings

Rafts:

No

Supports:

No

Resolution:

0.2

Infill:

100

Post-Printing

Power Supply

Don't forget to attach your LED ring to a power source like the printer's PSU ( i added plugs from old PC fans too). I used a 12V ring which is a perfect fit for the 12V AI3M PSU.

You may also want to add a switch to be able to turn off the LEDs - otherwise the LEDs will light up as soon as the printer has power. LED intensity was fine for me but could be adjusted by lowering voltage with a step-down bucket converter.

Category: 3D Printer Accessories