Snail trap

Snail trap for the garden. Fill it with approx. 300ml of beer and two table spoons of sugar.

Staut beer works very good!

Heavily influenced by this great design: https://www.thingiverse.com/thing:3635146

But it was to big for my PRUSA look a like, so I made my own design.

You have to separate the parts in the slicer, CURA can do it, so I suspect PRUSA slicer also can.

Glue the lid and lifting knob together and glue the three legs on, they have small pegs for alignment. I used thick super glue.

Remember enough bottom layers, so the bottom and sides are water tight! Would be a shame to loose all the beer without catching any snails.

I printed mine using Bondtech CHT nozzle at 0,3mm layerheight and 0,605mm line width and arachne engine. 

Prints without support.

Printed in PLA.