Makita / Festool Track Saw Guide Rail Holder

Printed with PETG. They look great. I haven't had the chance to attach to the wall yet but they fit the rails perfectly. Wasn't trying to be fancy, just ran out of black PETG and finished in red. Thanks for the files!

Sturdy enough to survive in my truck box for a year.
Used daily in winter and summer without issues.

These guide rail holders are fantastic. I made 4 total to hold my 106" and 55" Milwaukee guide rails, I found that an M5 nut and M5x20mm bolt worked perfectly to hold the pieces together. I used PETG with .24 layer height at 15% infill with a rectilinear grid pattern. (edited)

Works well.

Hangers work well. I had to scale up the knobs a little to get a better fit on the hex nuts I had.

One step to a more organized shop..great print I used PETG. Very useful!!! (edited)

Just printed 4. Easy to print and excellent result. I printed them with PETG.

Fits perfectly on the inside of my garage door and stay put when swung up overhead.
Cheap PLA, 0.28 super draft

Good fit. I found I needed to heavily over tighten the bolt then come loosen it to keep it from unscrewing itself when I rotate the top (using a round m6 instead of a hex head.)

Thank you for sharing. I ran with PETG - 6 lopes for wall lopes, 5 lopes for top shell layers, and 30% sparse infill density. This make easy to store the saw guide rails in my shop, all items fit together. (edited)

Great fit with my Makita track saw rails. Clean print, shop ready!

Thanks!

Printed in ASA, perfect. Nut fit snug in the spinning cap, bolt through the back was loose enough to get adjusted in the correct orientation to be snug when it turned to the right spot.
Thanks for this!