Fennec For V6 hotend

Parts List:
5015 Fan * 2
4040 10 fan
M4 nuts * 2
M4 bolts * 2 max length 20mm min 10mm
M3 bolts (from stock machine) * 6: Two for mounting onto x carriage, 4 for mounting the fan Max is 12 mm in length

M3 Heated Inserts *2
Optional
BL touch, plus mounting hardware
 

Printing tips:

Supports: required

For the fan ducts, use the flat face on the top of the duct so that the duct stands vertically, other orientations can work, but it is more consistent this way

Build guide

Place the two Heated inserts located on the edge of the mounting collar for the v6

Remove everything from the x carriage, and mount the back plate

Install the hotend, and place the two m4 nuts into the little slots on the upper arms

start to screw in the M4 nuts into the holes on the top arm. 

Take the two fan ducts and place the slots around the head of the m4 bolts

For Bl touch: 

Take the cover plate and mount the Bl touch to the two holes make sure the connector for the bl touch is facing away from the hole in the center of the cover plate

X offset: 45.55

y offset: 2

Your z offset is going to vary greatly, depending on hotend choice and your nozzle choice, a recommended starting place is going to -4.5

take the cover plate and line it up with the back plate, Screw in the two bolts that line up with the 2 heated inserts

Mount the 40mm fan into the 4 holes on the front of the cover plate and screw until tight

You Can now adjust the fan duct height using the m4 bolts

Have fun Printing