Gerber Armbar Drive pocket clip updated

Print as shown on the screenshot, without supports. I've used 0.4 line width, 0.2 layer height, PETG filament.

The part should fit very tigth inside the holes, use some force. No screws or glue needed. 

It doesn't make one-hand operation any harder or easier, it seems.

I'd be glad to make this thing better so please introduce your thoughts and suggestions!

That's why i did not upload any solid body files. PM me if you've got something on your mind anyway. 

For now, there are clean (not really grippy), knurled (the one on my photos), striped (3 straight lines) and dotted versions, though i didn't print the last two so i can't say if these print good and pretty.

UPDATES:

23.09.2022. Heavier duty tip up version uploaded. It's a bit bulkier so i've also left earlier version availible for download. I've used all the availible space for the hook piece so it barely fits in, bottle opener should be opened on a slight angle to make way.

25.08.2022. Captive nut version added. Use 2 m2.5 nuts and 2 flat head screw size m2.5x4.
Tip up version added, but you'll need to place supports as shown. It needs m2.5x4 screw and m2.5 nut. Also added a tip up version, it uses one screw and nut.