Print in place Jeep

This jeep was inspired by Vít Budina | Printables.com 

I made this so you shouldnt need supports but you may need to clean some artifacts after the print.

Print recomendations:

No supports.

0.4 nozzle.

0.2 layer high

Print sideways 

If you dont use high infill be careful with the shaft , remove the print whith your bed cooled down (Just to make sure I put my bed with the print on a fridge).

After the print the wheels may not move so carefully try to rotate them until they can move freely.

I havent try to print in smaller/bigger but it has big tolerances so it shouldnt be a problem.