Stonfo holder.

Welcome maker!
This is a simple project to help out anglers like me with stonfo hook tyer. It requires 4 nuts, a flexible wire I used 0.8mm, washer and a M8 threaded rod (lenght of the rod is up to you!).

First you need to disassembly the back side of the stonfo tool, just remove the cap and pinch the latch so the handle slides off, now you just put the handle into the upper slot of the holder, it should snap and hold nicely and you still can turn the tool around.

I use the vise to hold everything and tie some awasome same lenght leaders for my fishing setups!
 

As for a printing setting the most relevent thing is the orientation, just check photo :)

Hope this models helps You, enjoy!