Prusa MK3/S Y-Rod Mounts (no cable ties)

I was looking for an upgrade of the original Y-Rod holders that are shipped with the MK3/S and came across the one from MarcoZ76 which was going in the same direction I had in mind. However his Version uses a screw and I wanted it to be compeltely screw or cable tie less and held by friction (basicalle the original one is also held by friction and the rods can go nowhere).

So I redesigned this holder but changed a few things from the original design of Marco.

1) I designed my version without the grub screw
2)I wanted to use the original M3nS nuts and therefore added a pocket
3) The original version has a little nose that fits into the aluminum profile so I added that one too.

It tool me a few versions but this one fits perfect.

Print instructions

I printed it in Prusament PETG with 100% infill and no support