Mini Plant Pot Seed Starter

I was inspired by this Self Watering Seedling Planter: https://www.thingiverse.com/thing:3013386

⬆ It worksgreat for coffee filters, but I needed something to get seedlings going in little peat starter pots. Here are the various versions that I made.

V1: original, a bit thicker and taller than necessary https://www.tinkercad.com/things/baGWE3qKWVf-minipot-starter-v1

V2: slightly thinner, smaller reservoir https://www.tinkercad.com/things/1Rjwboyd76X-minipot-starter-v2-thinner

V3: thinner, slightly shorter, the base is perhaps a bit too thin https://www.tinkercad.com/things/1xRtTgF1DIh-minipot-starter-v3-thinner-still

V4: thinner and shorter than the original, but still sturdier than V3 https://www.tinkercad.com/things/8jE4SObTSW5-minipot-starter-v4

2022-04-12 Update: created a V5 that has the base angled out a bit, to make it a bit easier to clean/water

V5: https://www.tinkercad.com/things/1XcW3phNrz1-minipot-starter-v5-angled-reservoir

Print Settings

Printer Brand:

Creality

Printer:

CR-10S

Rafts:

Doesn't Matter

Supports:

No

Resolution:

0.2

Infill:

15%

Filament: AMZ3D PLA clear