Angled spacer for Kitronik :MOVE mini MK2 buggy

The Kitronik :MOVE mini MK2 buggy is lovely, but its default setup assumes you're using a very slim USB cable. This replacement spacer bar angles the micro:bit slight further out from the Kitronik Servo Lite board, allowing the use of most (?) micro USB cables.

Note that the spacer bar can't be seen in the photo

Print Settings

Printer Brand:

Prusa

Printer:

I3 MK3S

Rafts:

No

Supports:

No

Resolution:

0.1 mm

Infill:

15%

Filament: eSun PETG Transparent Green Post-Printing =============

Installation

Place the spacer between the Servo Lite Board and the micro:bit with the slightly narrower side facing down, then secure the assembly with the screws provided with the :MOVE mini kit.