Gyroid lamp

A small lamp (diam 75mm, height 150mm) exposing the gyroid infill to diffuse shiny light.

Print instructions

I've used two filaments for the print (out of the 5 on my MMU), the extruder 1 is loaded with Jet black PLA and the extruder 3 is loaded with Filamentum crystal clear (and I've raised the temp of this last one to 220°C to make it less brittle).

And then I've used patience since, in the provided .3mf file, the infill of the lamp itself is all printed with extruder 3, while perimeters are printed with extruder 1, so there's a lot of tool change. But it brings a bit more consistency and rigidity to the design by itself.

The base is made for a LED light bulb mounted on a GU10 socket. This is one of the wall mounted light bulb you can find anywhere, and it fits just nice (I'd avoid any incandescent light since the light bulb touch the PLA, it might melt it).