Xbox 360 Camera Modular Mount

An Xbox 360 camera mount that is compatible with yyh1002's Modular Mounting System.

There are two versions:

*codeandmake.com_Xbox_360_Camera_Modular_Mount_v1.1.stl has a connector that is the same length as the connectors in yyh1002's Modular Mounting System. That means this version can be used with the nuts available in the Modular Mounting System. **codeandmake.com_Xbox_360_Camera_ModularMount-_Connector_Extruded_5mm_v1.1.stl* has a connector that has been extruded by 5mm to allow an M5 wing nut to be fitted. This is the version shown in the pictures. The wing nuts shown measure 21.5mm at the widest point. If you are using this version, you may also be interested in my remix ofFlat_stand.stl from yyh1002's Modular Mounting System, which is also compatible with M5 wing nuts.

Please see my make for additional pictures.

This design is*completely free* and shared under a permissive license. Your support is hugely appreciated.

Did you know?

Some of our designs cannot be found on Thingiverse. If you are looking for more, check out our premium projects:

https://codeandmake.com/premium

Versions

• 1.1 (9 Dec 2020) - Rotated into printing orientation
• 1.0 (26 Jan 2018) - Initial version

Printing

We suggest printing this upside-down with base-only supports, as shown in the pictures.

• Resolution: 0.1mm - 0.2mm
• Infill: 10 - 25%
• Supports: Doesn't Matter
• Rafts: Doesn't Matter

License

"Xbox 360 Camera Modular Mount" is licensed under the CC BY license by Code and Make.

We are proud to offer content to you absolutely free.

We love to create free content for you. As you might imagine, it takes a lot of time. Supporters help us fund materials and equipment to create future projects and tutorials. To show your appreciation, please use the link below:

https://codeandmake.com/support

We thank you so much for your support!