Camera Rear Lens Cap - Canon 54mm

I needed a new rear lens cap for my canon lens. This will fit (what I assume is standard) 54 mm rear lens. I printed it with PLA and it is a nice snug fit.

UPDATE 11/18:

• Fits most 54mm rear lens (tested on Canon 24mm 3.8, 50mm 1.8, 18-55mm 4.0-5.6)
• Adjusted the threading to 'tighten' as you screw it on for a better hold
• Added gripped ribbed version of the cap

Future Versions:

Version 2 (It's here!): Will have grip ribs around the end like a standard cap. ~~Version 3 (coming less sooner): Will have customizable text on the top to write which lens size it is.~~ -To difficult to export to SCAD. I will just make common sizes.

Version 4 (coming whenever): Will have a belt clip holder for easy access when shooting

Print Settings

Printer:

Anet A8

Resolution:

0.1mm

Infill:

100%

Filament:

Any PLA

Any

Notes:

I originally printed this with the opening on the build plate (creating support inside), but it was quicker to print with the opening up (support on the edges). It reduced 13 mins from my Anet A8.

**Supports:** You will want to have supports everywhere. The inside threads need it (at least with Cura)

Category: Camera