Wire spool holder

I am using a lot of these electronic wire spools for my projects. They are good in use but not so good to store when you not use them, because they are not good to stack and create a mess all the time...

Therefore i made this little wire spool holder which can hold up to 8 of these spools.

The wire of each spool can be routed through a 3mm hole in the front of the base part.

The spools itself have the following dimensions:

• Outer diameter: 90mm
• Inner diameter of the hole: 30.25mm
• Width: 16mm

The spools are held in place inside the base part with a screw and a nut which are printed as well.

Printing instructions:

• 0.3 speed profile
• Brim for the base and screw part active
• Supports set to overall for the base and from the bed for the screw
• See pictures for details please

Happy printing :)