Shower Soap Holder

This soap holder is designed to hang on the edge of a 8,5 mm thick glass shower door, while overhanging into the inside of the shower.

Ridges and slotted holes at the lowest point shall let the water dry off from the soap block. The soapy water is designed to stay away from the shower glass or wall and drip inside away the shower.

Printing shall be done on one side with a brim to stick to the printbed. One side of the model has a rounded edge, while the other one has a sharp edge to stick to the brim.
The brim shall be cut away cleanly and the edge can be rounded by sanding it.

Printing this in the described orientation needs no support and also leads to the layer lines oriented in the direction of gravity.