Bondtech LGX Lite Direct Drive Mount for Manta Mk2

I created this remix to mount my Bondtech LGX Lite Direct Drive Extruder to the Manta MK2 tool head system.  

Installation:

1. Install the Bondtech LGX Lite to the mounting plate before installing it onto the Manta MK2 tool head
2. Route wiring according to original Manta MK2 instructions
3.  Install the mounting plate using 3x8mm screws in the locations circled in red (two of the mounting holes can't be used due to the location of the extruder.  The mount is plenty sturdy with 3 screws).

Printing:

Supports are necessary due to the countersunk areas on the bottom side of the part.

Printed in PETG 35% infill with 4 perimeters