Lego Heater Shield (Wolfpack & Blank) 10:1

I decided to make my Lego Skeleton in to a castle era model.  Looking online there were not any high quality shield STLs available.  Using a stl from printablebricks as a template, I rebuilt it in tinkercad and included the classic Wolfpack logo

I have included a blank version of the shield incase anyone wanted to paint or remodel their own designs.

Handle slides perfectly into the skeletons hand and has enough friction to stay in place.

PRINTING

This was printed on a Elegoo Neptune 2s using Eryone Agate grey.  Printed at 0.2mm layer height.  I recommend using 4 top layers as this will give you one complete grey layer across the surface before layering up the wolf pack logo, if you plan to swap out filament to give the wolfpack logo a different colour.  The shield pegs are to help with alignment and would recommend printing on a small raft to help with adhesion.  The handle require supports but have aligned the print so that the supported edge is hidden by the shield itself.

Happy Printing!