DigiPi Case

First ever case for the digipi. This is a work in progress and I am open to ideas for changes. This case was made for the audio injector board with room for a PTT circuit.

All holes are for M3 screws and designed to be self tapped by driving the screw in to allow it to cut its own threads.

Connector used is a RC servo style or JST SM 5 Pin connector. Only using 4 pins, just using 5 for alignment.

Printed at .3mm layer height at 100mm/s  Because I was prototyping. 

Would be really nice at a smaller layer height and slower speed.

Didn't need any supports