Anycubic Kobra Z-Axis Dust Cover Grease Protector

A simple quick print that shields the area around the z-axis screw preventing dust and debris from getting into the grease lubricant. This will prolong the life of your z-axis assembly. 

Uses the pre-existing cable holder hardware to secure itself.

Printed with no supports at 0.15mm layer height and slowly (around 30mm/s).

Some minor sanding may be required to the z-axis hole if your print results in poor tolerances.

During assembly make sure there is a very small gap around the whole of the z-axis screw to ensure the cover does not drag on the z-axis during printing. Pack the inside with grease when installing.

Printed on Anycubic Kobra using Anycubic Green PLA.