Stanley battery 18V wall holder

I wanted to have my Stanley 18V batteries for drill and impact driver on a wall, so I made a simple wall holder for them.

At first, I want to made them with simple lock, but after version 1.2 there was no need as battery is holding quite good on its own due to their locking mechanism.

Holder is a little bit wider, than battery, so you can install more holders side by side and batteries will fit.

I printed holder standing, so there is no need for supports, but first model had little warp, so next one was printed with 2mm skirt.

I also  printed with 4-5 perimeters to add rigidity.

There is no special shape (except holes for screws), so you can print it with layer height 0,2 or higher.