This is just another vertical macbook pro stand. It may look remixy, but there isn't a lot of variety for shoring up a vertical laptop stand. I sketched this out in shapr3d because I couldn't find my commercial laptop stand anywhere.
Filament: prusament petg clear green
Supports: nope
layer height: anything you like. I printed this with a 0.6mm nozzle with the 0.3 detail preset in PrusaSlicer
Infill: I used 25% adaptive cubic, but you can probably do fine with the default 15%. Print time was not noticeably impacted until I toggled infill up past 60% because of how skinny the solids are
remixes: go wild. it's triangles and a rectangle. the weirder the better, IMO.
I'm including my gcode for my Prusa Mini for the sake of example. Once again, this is for a 0.6mm nozzle and I have an extra bit of feed because I have a Revo hot end and also throw a retract at the end of the prints so I can swap nozzles without unloading my filament.
The author hasn't provided the model origin yet.
