Screw top box for holding wire earphones

A screw top container for holding wired earphones.

They are kept neatly and when removed, come out without tangling

Wrap around 2 or 3 fingers and put in container around the centre cone.
If lifted out from either end they don’t get tangled

Print instructions

This is based on Prusa Thread modified.

Parts 1 Body holding the earphones with cone in the centre. 2 .stl files for wall/cone and one for the bottom. If loaded together into Prusa slicer can be printed in single colour or the two parts different colours.

Two versions of the  body are different depths for different size earbuds

            2   Lid Shown in photo with 3 different coloured patterns for MMU2  3No  .3mf files

The 2 celtic patterns have an infil file. This is behind the pattern and can be coloured to keep the top colours clear.   Usually set the same as the inlay colour.


An .stl file of a self coloured lid included. 

On completion it helps to scrub fine filaments from the threads with a toothbrush and then run a candle around the thread as a lubricant