Angry Knob (Anime reference)

This is super simple to print.  If you want mono, just slice the stl or load the 3mf and go.  2 perimeters, 20% grid infill.  The bottom of the button goes against the build plate.

If you want two color, I set the 3mf to use filaments 2 and 3 on the MMU2.  2 is my black and 3 my orange.

The Prusa gen 2 stock knob was an improvement over the first design, and frankly I prefer this one to the stock one.  These are both going into service in the shop.