Tolerance Tree

I put a flat edge on one side to optionally print vertically and included a selection of various tolerance tests.  The cylinders are designed to pop out if tolerance is adequate.  There is a taper on the bottom to avoid any first layer squish issues.

#1 is 0.1 to 0.9mm in 0.1mm increments

#2 is 0.05 to 0.85 in 0.1mm increments

#3 is 0.05 to 0.45 in 0.05mm increments

#4 is 0.6 to 1.0mm in 0.05mm increments

#5 is 0.2 to 0.6mm in 0.05mm increments