6mm pot knob

Simple knob, useful for volume potentiometers. Overall diameter is 18mm. Shaft is 6mm (slightly oversized at 6,2mm actually) diameter and 18mm length. Knob has additional 4mm cover after the shaft. It was designed for the TKD 2CP-601, but will fit other pots fine.

Prints without supports from the bottom. You can change filament for the last 2 layers for a cool effect and better visibility. If you're overextruding and it doesn't fit even with the oversized hole, just do one quick pass with a 6mm drill bit on the finished print.