Roll-up Bag Clip (Print-in-place)

This is a bag clip which might be a bit more complicated than it needs to be. I designed it for the Bag Clips Contest and so I wanted it to be slightly unusual. It's also the first print-in-place model I designed.

In order to close a bag with it, you need to extend it, clip one side onto the bag, roll the bag around it and secure it in place it by pushing the clip together again. (I hope the pictures make it clearer)

I printed the part in PLA with a layer height of 0.15mm. Make sure that the part is correctly oriented on the print bed.

If you want to have a smaller version, I found that one could scale the model down to around 66% of the original size without issues. (Altought you might need to seperate the two parts using a toothpick or similar)

 In case you have questions, remarks, suggestions, I would be happy to hear from you.