Random Noise Lampshade

A series of random noise lampshades. Made to fit on a table lamp base, but could also fit on a ceiling hanging light fitting. 

Use the Python script to change parameters. Running it will generate a scad file which you can render with OpenSCAD.

Lamp Compatibility
I designed this lampshade to work with standard shade mounting systems. I've been using lamp bases that take an E14 bulb and have a ~28mm diameter male thread for the shade mounting. The adaptor dimensions can be adjusted to fit larger light sockets.

Print Settings and Tips
Printed in vase mode (single wall spiral printing). I used the following settings and found they worked well:  
- Material: PETG (PLA works fine but may warp if you use an incandescent bulb or leave it in direct sunlight)  
- Layer height: 0.2mm  
- Line width: 0.6mm  
- Solid bottom layers: 6  
- Try printing with fuzzy skin for a different look

Print both the lampshade and the adaptor. I print the adaptor with normal settings (ie. not vase mode). I usually use PETG and a 0.3mm layer height. It does require supports unfortunately. Then glue the adaptor into the bottom of the lampshade with CA glue.

See my other lampshades here.